COBRA PRO TINTABLE All-in-One KIT - 800ml (Includes Superior Spray gun)

Cobra Pro – Professional Finish. Extreme Protection.

When results matter, Cobra Pro is the surface coating that delivers both performance and polish. Designed for tradies, detailers, and serious DIYers, Cobra Pro provides a high-gloss or matte finish with elite protection that holds up to Australia’s toughest conditions.

Key Benefits

• Extreme resistance to scratches, chips, impacts, abrasions & UV

• Customisable finish – high gloss or matte (with optional matting agent)

• Compatible with spray guns, Schultz guns or rollers

• Delivers a sleek, automotive-style finish with proper prep

What’s Included

• 1 x 600ml Cobra Bedliner Superior Tintable Base

• 1 x 200ml Cobra Superior Hardener

• 1 x Cobra Superior Spray Gun 

💡 To customise your colour, mix with a solvent-based automotive tint.

Tinting it: 

The golden rule: pigment goes in the base FIRST, hardener second. Once the hardener is in, you can't re-tint it.

Steps

1. Use the right pigment. Standard automotive 2K urethane tinting paste/pigment only (Novol's Spectral 2K or Spectral Base 2.0 pastes are the matched ones). Household paint, water-based tints or craft pigments will wreck the adhesion and durability.
2. Work out how much. Pigment is 10–15% of the tintable base — 15% is the hard ceiling. For the 800 ml kit (600 ml base + 200 ml hardener), that's roughly 60–90 ml of pigment into the 600 ml base.
3. Add it gradually — start at the low end, stir 1–2 minutes until the colour is completely even, then check it on a bit of card. Expect the cured colour to come out a bit lighter than the pigment chip.
4. Then add hardener at 3:1 (3 parts tinted base to 1 part hardener) and mix again.
5. Thin only for texture, with acrylic thinner: 0% for a coarse finish, up to ~5% for moderate, 25–30% for a fine finish.
6. Pot life is about 60 minutes at 20 °C, so only mix what you'll spray or roll in that window.

Coverage: 

• 4m2 - gun nozzle at 4mm
• 5m2 - gun nozzle at 2.5mm
• 6m2 - gun nozzle at 1.4-1.8mm

Ideal For

Automotive:

• Full body resprays, ute trays, bull bars, boot interiors, trailers
  Marine:

• Boat hulls, engine housings, paddles, oars
  Industrial/Farm:

• Silos, ploughs, seeders, trucks, tankers
  Home & DIY:

• Anti-slip steps, fences, gates, furniture, toolboxes

Pro Tip

For the best finish and unbeatable durability:

• Use Cobra Pro Primer for maximum adhesion

• Apply with the Cobra Pro Spray Gun for a clean, controlled result

⚠️ Warning

This is a permanent coating. Always test first on a disposable surface if unsure. Once applied, it cannot be removed.

🔍 Need help with application or colour mixing?
Visit our FAQs or HOW TO section for step-by-step guidance.

Built for Professionals. Designed to Impress.

Cobra Pro – Serious protection. Serious results.